hi all,
just put a jimny efi engine into my zook, and need to wire up the tacho.
How would i go about this, it has two coil packs, one for 2 and 3 cyl and the other for 1 and 4.
The original tacho was wired up to the single coil on the old carb engine.
Thanks
Brenno
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Jimny swap tacho wiring
Moderator: -Scott-
Jimny swap tacho wiring
85 LWB w. FRP Canopy
Ca18det conversion in progress, Vit PS, RUF,
6.5:1's, 33x12.5 Bfg's, custom front and rear bars.
Ca18det conversion in progress, Vit PS, RUF,
6.5:1's, 33x12.5 Bfg's, custom front and rear bars.
Who is online
Users browsing this forum: No registered users and 0 guests