Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

35 degress

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 791
Joined: Fri Mar 17, 2006 7:45 pm
Location: Gold Coast QLD

35 degress

Post by NCpaj »

Ive read in the tech articles and in my pajero manual that the maximum angle the pajero can be driven on is 35 degrees. Why only 35. What happens after 35 degrees.


The only real time ive driven for and extended period of time over 35 degrees was up a step fire trail and the g/box freaked out and fel out of 1st low and engagded reverse as well :shock:
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
Posts: 14209
Joined: Sun Jan 11, 2004 11:36 am
Location: Adelaide

Post by -Scott- »

I think they needed a figure, so they picked 35 degrees. Beyond that, I guess it could struggle for traction on climb/descent, and there's the roll-over prospect on a side slope.

It's a general guide, not a hard and fast rule.

Scott
Posts: 1130
Joined: Thu Nov 18, 2004 7:25 pm
Location: New Zealand

Post by NJV6 »

Yea, the 'O dear - I think i just soiled my pants' rule usually kicks in about then... :? !!
1994 NJ SWB, 3.5, 5 speed manual, 33's, XD9000, 4.9 diffs, Front & Rear ARB's, Safari Snorkel

2008-2009-2010-2011 Pavlova in the shed.
Posts: 728
Joined: Sun Aug 24, 2003 8:46 pm
Location: Canberra (too far from the sea)

Post by twinnie »

after comming down a long 35 ish slope i was followed by a bit cloud of smoke, ok it was more of a small cloud. but i point is that the oil moves and doesn't reach where it's needed at those angles. one of the more techy guys and fill in the huge gaps i have left.

Matt
Posts: 82
Joined: Tue Jan 14, 2003 3:41 pm
Location: Kansas City, USA

Re: 35 degress

Post by Alex Kogan »

NCpaj wrote: The only real time ive driven for and extended period of time over 35 degrees was up a step fire trail and the g/box freaked out and fel out of 1st low and engagded reverse as well :shock:
Hava you actually measured that slope. Or was it seat of the pants feeling. 35 degrees is hell of lot steep. If it was a 2nd then usually its about = 2 * actuall slope. One would be really hard pressed to find slope over 35-40 degrees this side of the rock face. Generally loose material cannot creat slope over 40 degrees it will just colapse.
92 Montero SR, 285/75R16(33-11.50/R16) Yokohama MT on 16X8 Eagle 149 alloys, brush guard, Rear ARB, GAST air compressor, AirLift 1000, OME. MileMarker 10500
2002 GL, 285/75R16 SuperSwamper TruXus MT
Posts: 728
Joined: Sun Aug 24, 2003 8:46 pm
Location: Canberra (too far from the sea)

Post by twinnie »

the pajeros have a built in inclonomiter and i have seen one hit 40 degrees (it was in zoot's lwb he was to busy reversing down a hell of a steep fire trail to be watching it.

matt
Posts: 791
Joined: Fri Mar 17, 2006 7:45 pm
Location: Gold Coast QLD

Post by NCpaj »

yeah i got one of those incilometers and from memory it said round 35' . And yes i was sh*ting myself cause i had to make it to the top or reverse down.
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
Posts: 109
Joined: Sat Dec 17, 2005 11:46 am

Post by 4wd26 »

I do these kind of angles on a weekly basis for my job.
You are correct in the assumption that loose material (angle of repose) is around 35 degrees for sand and 37 degree loose rock (Mine surveyor talking here) And you are again right in saying angles feel twice as bad as they really are

I get to drive down these angles in a sand mine all day long!!!!
You have BIG problems getting up the dunes anything above 17 degrees.
Posts: 1046
Joined: Sun Dec 12, 2004 11:24 pm
Location: ACT

Post by Zute »

Um, while I would like to bragg of being able to drive up 40deg slop and reverse down again. It was more like 30deg. sorry Matt.
'2001 Disco td5
'90 Maruti Ute 1Ltr Lwb

Experience is something you don't get, until just after you need it.
Posts: 728
Joined: Sun Aug 24, 2003 8:46 pm
Location: Canberra (too far from the sea)

Post by twinnie »

Zute wrote:Um, while I would like to bragg of being able to drive up 40deg slop and reverse down again. It was more like 30deg. sorry Matt.
the slope might have been 30 degrees most of the time but comming of the last hump (the first one you reversed off) it was on 40 degrees, if only for a second. but your right i'll shut up now :oops:

Matt
Posts: 82
Joined: Tue Jan 14, 2003 3:41 pm
Location: Kansas City, USA

Post by Alex Kogan »

One other factor is suspension. Climbing steep hill front suspesion relaxes while rear is compressed which can lead to perception of steeper angle than it actually is. I'd say 5 degrees or more is not out of the question. Same happens down hill and traverse.
92 Montero SR, 285/75R16(33-11.50/R16) Yokohama MT on 16X8 Eagle 149 alloys, brush guard, Rear ARB, GAST air compressor, AirLift 1000, OME. MileMarker 10500
2002 GL, 285/75R16 SuperSwamper TruXus MT
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest