Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Starter motor wont crank.

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 36
Joined: Sun Dec 11, 2005 12:04 pm
Location: Brisbane

Starter motor wont crank.

Post by luxdriver »

22r 2.4L Petrol engine and I just tried to kick it over to duck home for lunch and the starter seems to be gone. Just wanting some advice on what I should check before i pull it off the engine and have it re-worked.

I have cleaned terminals and checked all the leads, but dont know if there are any other little gremlins that other hilux drivers know about?

Also if it does need to be fixed what sort of $$$ am I looking at and does anyone have a recommendation for a good (read as cheap) auto lec in brisbane?
1990 2.4L Petrol 22R Hilux,2 inch suspension lift,33inch muddies,front and rear bars,spotties, uhf.
Top
Posts: 771
Joined: Wed Jun 23, 2004 9:34 pm
Location: greensborough, vic

Post by big bundy »

are u getting a 'clunk' when u hit the key? could be full of crap, just wack the solinoid with a a hammer for a temp fix.
bundy's suck ass
LWB patrol's are where its at!
Top
Posts: 317
Joined: Sun Jul 17, 2005 8:08 pm
Location: western australia

Post by crack »

i did it myself cost me 30$ from memory for the bushes and i gave her a clean out with compressed air. yeh just check all your leads etc not a flat battery is it?
If all else fails, use a bigger hammer

hilux- locked lifted and turboed
Top
Posts: 3523
Joined: Fri Aug 27, 2004 12:27 am
Location: Fairfield,Sydney

Post by pongo »

The contacts are a common problem on this model. been there fixed that, and no amount of massaging with a hammer could get it to fire.

:roll:
Top
Posts: 2097
Joined: Tue Aug 12, 2003 6:50 pm
Location: wollongong

Post by dow50r »

If it goes clunk when you hit it, you didnt miss :)))
Go aftermarket for the contact, as yota want $50 for the contact with its bolt and washers, etc etc you can reuse them all and just get the contact aftermarket for $8
These live under that funny tim flat plate on the side of the larger cylindrical motor...3 small screws reveals it all....the contact is on the other side of the power lead....
You will only need one contact, one will be as new.
Andrew.
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 1 guest