Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Rangie door not opening

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 4
Joined: Mon Apr 17, 2006 7:49 pm
Location: mulgrave, Vic

Rangie door not opening

Post by lost_motor »

G'day guys

i'm a newbie to the 4x4 scene and the forum. Recently bought an 84 rangie and trying to get RWC for it. :cry: When i got the car the RHS rear door opens, but now i can't get it to open

any help or suggestions would be greatly appreciated, or even schematics to getting to the internals of the door

Cheers

lost_motor
Top
Posts: 3278
Joined: Mon Mar 03, 2003 9:03 pm
Location: St Helena, Melbourne.

Post by Loanrangie »

The handle wont open from the outside ? could be the rods to the catch, pull the door trim off and check if it has come off. Aslo if you update your profile with your location there may be someone local who could assist.
Saddle up tonto, its the not so loanrangie! . 98 TDI DISCO lightly modded with more to come.
Top
Posts: 1057
Joined: Mon Feb 10, 2003 12:28 pm
Location: Eastern Sector

Post by mickrangie »

not to hijack but

my drivers door wont open from the inside after a recent 4x4 trip :(

and my pass rear door hasnt opened from the out side for a long time...... everything is still hook up on the inside of the door so i have NFI

so if anyone has a how too i would be very greatfull as would lost_motor

Mick
TD5 96 Discovery UTE.
Top
Posts: 3278
Joined: Mon Mar 03, 2003 9:03 pm
Location: St Helena, Melbourne.

Post by Loanrangie »

Hijacking post biatch !
Saddle up tonto, its the not so loanrangie! . 98 TDI DISCO lightly modded with more to come.
Top
Posts: 1057
Joined: Mon Feb 10, 2003 12:28 pm
Location: Eastern Sector

Post by mickrangie »

nah just adding fuel to the fire the way i see it :P
TD5 96 Discovery UTE.
Top
Posts: 4
Joined: Mon Apr 17, 2006 7:49 pm
Location: mulgrave, Vic

Post by lost_motor »

door won't open from both sides. To pull the door sill off, it's just taking the adhesive off and then putting new adhesive on, right? Scared that i might not be able to put the sill back on properly.
Top
Posts: 1175
Joined: Wed Jul 27, 2005 10:17 pm
Location: Mirboo North

Post by 6.5 rangie »

I'm confursed, do you mean door trim? If you do hten just pull it of as it has clips that just press back in.
Top
Posts: 463
Joined: Sun Nov 21, 2004 10:15 pm
Location: Kingston,Hobart, Tasmania

Post by justinC »

If what usually happens to these has happened, try unlocking with key at the same time as you pull exterior handle, sometimes the little latch overcentre spring breaks, and as you pull the handle, the latch actually locks itself. You need to hold the lock mechanism up while pulling handle, either with inside lock button or key, and it will overide this problem. I'm not sure this would work with the 2 door RR as their latches are quite different. Works with Disco 1 and RR 4 door.
Good luck
JC
'92 Rangie Sherwood/turbo intercooled isuzu4BD1 /ACE/ full leather/2.5" exh/2.5" body lift/DeCarbon shocks/LR tanks/LT95 back in and OK now, Sals conversion soon...
Top
Posts: 1005
Joined: Sat Aug 02, 2003 8:34 am
Location: Croydon, Victoria

Post by TRobbo »

I've had a similiar problem after a trip (read stuck in bonnet deep bog) and found that after the door trim was pulled off, the inside of the door cleaned and some CRC it all started working again, thereafter I was able to get inside the door to properly clean and lube.
Warn - Dont leave home without it
Top
Posts: 4
Joined: Mon Apr 17, 2006 7:49 pm
Location: mulgrave, Vic

Post by lost_motor »

thanks everyone for your help

i tried the method JC suggested and it opened :)
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 2 guests