I'm performing a SOA on a '94 Samurai, is there a need to make some modifications (cut, weld,..) to the crossmember that hold the tranny and t-case?
Will the front drive shaft hit it?
Thanks!
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Crossmember modification - SOA
Re: Crossmember modification - SOA
if its real flexy it may hit it on droop but nothing to worry aboutbuger wrote:I'm performing a SOA on a '94 Samurai, is there a need to make some modifications (cut, weld,..) to the crossmember that hold the tranny and t-case?
Will the front drive shaft hit it?
Thanks!
Team UNDERDOG #233
WERock Australia thanks to
[url]http://www.longfieldsuperaxles.com[/url]
[url]http://www.rockbuggysupply.com[/url]
WERock Australia thanks to
[url]http://www.longfieldsuperaxles.com[/url]
[url]http://www.rockbuggysupply.com[/url]
mine is touching the x-member just sitting there.... we're gonna chop it up and move it back and incorporate roc7oy's tcase ring into the new x-member.... the end result should look factory as.
if its only just touching you could take to it with a hammer? =)
if its only just touching you could take to it with a hammer? =)
The worst thing about censorship is ███████.
Who is online
Users browsing this forum: No registered users and 0 guests