Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

swaybar disconnect question

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 20
Joined: Thu Jul 24, 2003 3:20 pm
Location: Melbourne

swaybar disconnect question

Post by scruffy »

could some one give me a few pointers on where not to use the disconnect rear swaybar handle,
a mate has said not on angles as the vehicle will tend to roll,,
any other opinions please,
thanks inadvance
Scruffy
89 lwb gq
Posts: 4275
Joined: Fri Nov 22, 2002 6:41 pm
Location: Western Australia

Post by Hoonz »

i've removed the swaybars on my ute .... to much hassel disconnecting them all the time .... just have to drive a lil slower round the corners
off road would leave it dissconected .... dont drive sidewayz on slopes :D
i've been on some wild angels ..... so i think anyhow ... its all line of attack
JK
Posts: 3229
Joined: Tue Oct 22, 2002 9:00 am

Post by JK »

What lift you running?

With a 4" and over, you can totally stuff a swaybar as you will have more flex than the bar can handle.

I have lost mine altogether. I don't miss them either. Good shocks have a lot to do with good road manners and bodyroll.

Offroad bodyroll on sideslopes is not an issue for me either.
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...

Post by Area54 »

On my family wagon I've put the rear swaybar back on - rig handles better all around. The swaybar isn't real big to influence the handling off road anyway. We run a 6" coil, I've lengthened the links to correct (neutralise) the bar's location. I feel the swaybar evens out the handling offroad - helps to place more (marginally) pressure onthe front end to perform - the rears are quite flexy. I wouldn't stress too much where or when you disconnect the bar.
Posts: 2388
Joined: Sun Nov 24, 2002 10:20 pm
Location: bacabugari

Post by big red »

do you mean the factory disconnect? if so all it does is allow one end of the sway bar to move up and down about 40 mm or so.
Even 2" lifted springs can put too much stress on the little balljoints on either side of the swaybar if you dont disconnect it when in terrain that causes one rear wheel to to flex a fair bit.
Use the disconnect when driving over undulating terrain [to take the pressure off the little ball joints].
And use the disconnect whet travelling over potholed or rough ground as it allows one wheel to drop into holes without pulling the whole body down and makes it a much more comfortable ride.
The disconnect makes buggerall difference to side slopes unless your right on the point of rolling over.
shane :)
[url=http://bigred.redbubble.com/][color=red][b]You can follow me but its gunna hurt ![/b][/color][/url]
event pics http://bigred.redbubble.com/
Posts: 20
Joined: Thu Jul 24, 2003 3:20 pm
Location: Melbourne

Post by scruffy »

Thanks guys,
I should of commented but i meant the factory disconnect handle in the cabin,,
I've got a 2"coil lift on my lwb gq and from i read in the thread off road i should pull use the lever to save stress on the sway bar its self,,
thanks for the advise
great information
Scruffy :D
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest