OK - if I leave my GQ Patrol Diesel sit for more than say 1 week - the battery struggles to start it from cold.
Once Im driving around it starts fine.
Im thinking that something is slowly draining the battery - when the cars switched off.
what Ive looked at so far with mutlimeter:
charging volts - OK
battery volts - OK
if I turn the vehicle off, remove key, then check between battery - and the - clamp with multimeter.
What amps should be acceptable ??
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Slow battery drain - what amps are OK
Moderator: -Scott-
Re: Slow battery drain - what amps are OK
Depending on what you have in there that requires constant power for memory (eg alarm, stereo, clock, dunno what else) I would not expect to see more than maybe 20 - 30 milliamps.BrettInUte wrote:OK - if I leave my GQ Patrol Diesel sit for more than say 1 week - the battery struggles to start it from cold.
Once Im driving around it starts fine.
Im thinking that something is slowly draining the battery - when the cars switched off.
what Ive looked at so far with mutlimeter:
charging volts - OK
battery volts - OK
if I turn the vehicle off, remove key, then check between battery - and the - clamp with multimeter.
What amps should be acceptable ??
Rather than current drain, a dying battery could be the cause. Your symptoms would be fairly typical for a battery that is near the end of its useful life.
Jason
This is not legal advice.
if everything was off(stereo clocks etc) then with the multimeter hooked up in series between the battery and positive terminal then the reading should be 0.0amps
around 0.01 to 0.15 i would think was normal depending on your dash clock etc.
0.5 would be like an interior light on or similar
just a rough guide, hope it helps:)
around 0.01 to 0.15 i would think was normal depending on your dash clock etc.
0.5 would be like an interior light on or similar
just a rough guide, hope it helps:)
"elephant lisa, it's an elephant"
"ahhhhhhh, boogie man!"
GO THE MIGHTY BLUES!!!
"ahhhhhhh, boogie man!"
GO THE MIGHTY BLUES!!!
A good alarm should only draw around 0.02 A (it will fluctuate with the flashing dash light.) Other devices with a permanent 12v supply for memory circuits etc shouldn't add much to this figure.
I'd say anything over 0.05A is worth investigating further (remove fuses one at a time to work out what it is
)
I'd say anything over 0.05A is worth investigating further (remove fuses one at a time to work out what it is
)David
Im probably stating the obvious, but make sure the top of the battery is clean, or at least, around the posts are clean, and crud free.
You can get voltage across the top of the battery, even if its not that dirty.
Clean by applying some bicarb mixed with water, allow to bubble, rinse off, then hit with hot water, and clean dry with paper towel. Apply either spray grease to the termials or grease by fingers, or vasaline. Anything to cover the posts and terminals.
Keep an eye on it.
You dont have an ear melting sound system with amps that resemble a power station in the boot or anything like that
.
hehe
Trains
You can get voltage across the top of the battery, even if its not that dirty.
Clean by applying some bicarb mixed with water, allow to bubble, rinse off, then hit with hot water, and clean dry with paper towel. Apply either spray grease to the termials or grease by fingers, or vasaline. Anything to cover the posts and terminals.
Keep an eye on it.
You dont have an ear melting sound system with amps that resemble a power station in the boot or anything like that
.hehe
Trains
Save the Whales......Collect the whole set.
My Wife Can't Shear..............But You Should See Her Crutch !
My Wife Can't Shear..............But You Should See Her Crutch !
OK - spent some time on sunday.
after figuring out I needed the multimeter inputs in the OTHER socket - I could happily measure the amps running from battery negative to the negative lead.
It was pulling 0.18 amps with the key off. - NOT good.
SO i proceeded to pull out all the fuses one at a time. did the factory ones first - then the ones I had added. watching the amps for each one.
the second last one I tried - dropped the amps from .18 to .01. Ah ha.
I chased the problem down to a single dodgey relay. it looked OK, and clicked on and off OK - but the pin that had the main power running out of it was slightly melted at the base. As soon as I swapped it with another higher amp relay - it all worked fine !!!
I think my 3 way fridge would have caused this. Ill keep an eye on it from now on.
cheers for all the advice guys....
after figuring out I needed the multimeter inputs in the OTHER socket - I could happily measure the amps running from battery negative to the negative lead.
It was pulling 0.18 amps with the key off. - NOT good.
SO i proceeded to pull out all the fuses one at a time. did the factory ones first - then the ones I had added. watching the amps for each one.
the second last one I tried - dropped the amps from .18 to .01. Ah ha.
I chased the problem down to a single dodgey relay. it looked OK, and clicked on and off OK - but the pin that had the main power running out of it was slightly melted at the base. As soon as I swapped it with another higher amp relay - it all worked fine !!!
I think my 3 way fridge would have caused this. Ill keep an eye on it from now on.
cheers for all the advice guys....
Who is online
Users browsing this forum: No registered users and 0 guests