Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Oil for turbo TD42 ...
Oil for turbo TD42 ...
Where do you usually steal the oil for the turbo on a TD42 ?
GQ 2.8TD. OME. 35 BFG. Fact. Rear Locker on steroids. Air Locker front. Gearmaster Reduction. 6HP Warn 8274.
Most kits take oil from the feed to the vacuum pump pump on the back of the alternator. You can install a t-piece there and get a hose made to suit. If the car is a later model with the vacuum pump over near the fuel pump, there is a plug in the block where the oil is normally sourced for the vacuum pump (sort of up the front of the block and below the exhaust manifold. It is some weird fitting into the block (tapered), but most hydraulic places should be able to sort you out.
There were a couple of similar threads a week or two back.
There were a couple of similar threads a week or two back.
Oil
Heymate, i have fitted a DTS turbo to my truck and they give you a drawing of were to spike the hole just above the oil line in your sump.Then tap it out to 1/2 BSP tread and seal it with epoxy glue. If you use the drain off the back of the alt it hasn't got enough flow .
Who is online
Users browsing this forum: No registered users and 104 guests