After replacing a lower balljoint on the weekend, I had the wheel alignment adjusted this afternoon. They gave me a print-out at the end, most of which means nothing to me, but I noticed the rear axle has total toe +7.1mm - on a solid axle. The wheel aligner seemed to think that one bolt missing from a control arm might be contributing, which I find a little hard to believe (and have since rectified) and apart from that, there's nothing that can be done.
Now, I think +7mm of toe (is that "out" or "in"?) is something to be concerned about. Anybody else have an opinion? What are my options here?
Scott
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Wheel alignment problem!
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Yes, total toe. +1.5 (L) and +5.6 (R), was +1.9 and +5.3 until he tightened one of the control arms (chassis end.)chops wrote:Scott, that was TOTAL toe.. ie both sides added up (could be 5mm one side, 2mm the other.. etc)
Got a scan of the printout handy?
I can scan it, but haven't got a photobucket etc. account to post. Got email?
Scott
Who is online
Users browsing this forum: No registered users and 3 guests