This may seem like a stupid question but i was under bruiser last night and noticed a bit of oil seepage from the axle housing half way between the centre and the wheel on the long side of the rear diff housing . there is on closer inspection a crack running around the axle housing approximately 3" long .
Is this able to be welded or will it have to be sleeved - or is it a replace entire housing job ?
I don't want anything to weaken the housing and my brother is a boilermaker and can weld it for me proffessionally . or sleeve it if it needs that .
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Diff/axle housing crack
Moderators: toaddog, Elmo, DUDELUX
Diff/axle housing crack
1991 Hdj80 ,
Drain the oil, grind it out ( not all the way through ) heat it up a bit get ya brother to weld it up . Leave all the weld dont grind it back smooth so it leavs the reinforcment and all will be cool.
Wally
Wally
THERES ONLY ONE SUBSTITUTE FOR CUBES AND THATS MORE and if you want more inchs stroke it !!!!!!!!!!!
Who is online
Users browsing this forum: No registered users and 72 guests