Six Shooter KnucklesTM are sold as a pair and include our set of special six hole shims for use between the top of the knuckle and the steering arm. Also included is a 1/2" course thread bolt to help remove the steering arms for knuckle service. To remove the steering arms, remove all 6 nuts, then install the bolt in the top of the arm. As the bolt is tightened, the steering arm is pulled up off the knuckle. Stock lower bearing plates and shims from your old knuckles are needed for knuckle assembly. A minimum of four additional steering arm studs are needed for installation. Six Shooter KnucklesTM are a Marlin Crawler design and are manufactured exclusively by Trail-Gear Inc. No questions asked, lifetime warranty on all knuckles, arms, rod ends and rods.
Our six stud high steer kit includes left and right six stud steering arms, tie rod, drag link, four rod ends and your choice of flat or curved pitman arm. To use this kit you will also need an IFS style steering box, box mount, Six Shooter Knuckle kit, and four additional knuckle studs.
just check the nuts are tight, its called maintance 
I lernt this the hard way 
