Page 2 of 2

Posted: Tue Jan 29, 2008 8:52 pm
by GRPABT1
Coil packs mmmmmmmmmmm nice.

Oh and yeah there is no fan on my car and hence no demister. But somehow it was engineered and I got a road worthy when I purchased it, this included a quick look by a DOT staff member.

I researched into the demister rules when I installed an electric water pump on my commodore. What I found was (in QLD anyway) that forced air onto the wind screen is the only requirement. No heating or cooling whatsoever. Hence alot of hot rod guys get away with a relocated 12V fan of whatever and just run some tubing behind the dash. This is what I'll do if I ever run into legal dramas.

Posted: Wed Jan 30, 2008 4:28 pm
by short stuff
nah microtech x4 and a mate choped the distributor to use it like a crank anlge sensor

Posted: Wed Jan 30, 2008 9:55 pm
by Wesley
MIK put the 671 and methanol inj back on your 289, pull the 9" outa the ford, buy some bucket tyres and put it all in the zook, Im sure it will go better in the dunes in 2wd than the 1L does in 4wd. Then you can take it up to the sand drags and pull 8sec 1/4s :D Sounds good to me ;)

Posted: Wed Jan 30, 2008 10:33 pm
by bazooked
wtf are u doin with internet?

Posted: Thu Jan 31, 2008 12:12 pm
by Spike_Sierra
i personally love my g13bb. with gearing they are very suffecient little motors. i can cruze 100clicks no worrys. easier than a carbi 1.3 to install...well nearly..

Posted: Fri Feb 01, 2008 5:34 pm
by mrRocky
Now i just have to find one thats not going to cost as much as a whole jimny.

Posted: Wed Feb 06, 2008 7:15 pm
by Wesley
bazooked wrote:wtf are u doin with internet?
:D looking at porn what else would i be doing with it :lol:

Posted: Wed Feb 06, 2008 9:48 pm
by mrRocky
well thats what im doin

Posted: Wed Feb 06, 2008 10:36 pm
by bazooked
hey mick a bit of topic :D , i need a few sheets of plaster board, can ya get a good price?. oh back on topic, have u found a motor yet?

Posted: Thu Feb 07, 2008 3:38 pm
by mrRocky
yeah tell us what size and thikness and how many
getting a price on a jimny halfcut from japan of a cannigvale importer just waiting on him to contact us. cant find anything at all elsewhere.
dont want to pay more than 3k though or i mayswell buy a rotary