Page 2 of 2
Posted: Sun Jun 13, 2010 7:49 pm
by GQ Toy
Ended up making my own captive mount for mine using a rear control arm bush and housing. Bit of mucking around to get all square, but i will have to break bolts or chassis for the engine to move now. This was a for a 92 efi petrol - same as 4 bolt diesel mount. Should have made a stack of them as the local boys go thru mounts pretty quickly.
Re: aftermarket engine mounts vs genuine nissan
Posted: Thu Sep 02, 2010 8:56 pm
by fatz fab
Hey lads we are a new 4x4 fabrication shop in rockhampton QLD and have just made the left side un breakable engine mount for the nissan td42. by replacing just the torque side it prevents the right side from breaking if it is a genuine nissan mount. We have a few of our mounts getting around in some local trucks and have never had any probs. any questions my mob is 0401612929 FATZ FABRICATION
Re: aftermarket engine mounts vs genuine nissan
Posted: Tue Sep 07, 2010 7:56 pm
by Mrowka
Dear Mr. Superior, please produce 4-bolt and 2-bolt unbreakable engine mounts for us Nissan Patrol owners please.
Re: aftermarket engine mounts vs genuine nissan
Posted: Wed Jan 19, 2011 3:43 pm
by blowngq
Dig dig, but yea come on superior make them we need em.
Re: aftermarket engine mounts vs genuine nissan
Posted: Wed Jan 19, 2011 6:27 pm
by its aford not a nissan
i just fixed mine so it wouldnt break again, i removed the thread and pin from the mount and replaced with a bolt that goes right through it , put a shockie rubber on then a washer and nut, no more vibes and i cant see anyway that i could break it short of a major accident
