Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Quick question on welding high tensile bolts?

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 835
Joined: Fri May 05, 2006 4:56 pm
Location: Sydney

Contact:
Contact brendan_h

Post by brendan_h »

fair enough. will hopfully going to bolt shop tomrow get some grade 8 (5/8) bolts
but would it be ok to use the stainless nuts and washers?
91 SWB Sierra. 16v 1.6efi, extractors, 6.1gears, SPOA, 32 BF muddys and 2inch bodylift
Top
Posts: 1009
Joined: Wed Jan 19, 2005 11:21 pm
Location: townsville

Post by brad-chevlux »

brendan_h wrote:fair enough. will hopfully going to bolt shop tomrow get some grade 8 (5/8) bolts
but would it be ok to use the stainless nuts and washers?

dude.... you will be at the bolt shop. stop being tight and just buy the right stuff
http://www.mothfukle-engineering.com/
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 1 guest