Yorker, sorry this took so long.Slunnie wrote:Thanks Lokka!Thats my work shed, where the Yr12's make their HSC major projects. When they're on holidays I'm still at work.
Gday Yorker, thanks for this . The guards are cut based pretty heavily on the militarys cut, it's all pretty straight forward and if you want them, I can give you the measurements for the cuts, as long as you have the straight edges etc. The cut that I run is slightly different, and is a hybrid between the mil spec cut and an Australian Series that runs mog diffs etc.
Measurements for the stocker (mustard coloured one):
Firewall to 1st corner = 3.5"
Firewall to 2nd corner = 16 3/4"
Firewall to 3rd corner = 39"
Nose to 4th corner = 1 1/2"
Top seam down to wheel oriface = 7" and parrallel
Front seam down along front panel = 16 1/2" and parrallel
Measurements for Ute2 (Blue coloured one):
Firewall to 1st corner = 3.5"
Firewall to 2nd corner = 16 3/4"
Firewall to 3rd corner = 39"
Top seam down to wheel oriface = 7" and parrallel
Front seam down along front panel/side panel = 13"
Front seam down to front panel/grill = 19" (full depth)
All of the measurements follow the panel rather than being flat vertical or horizontal measurements.