Page 2 of 2
Posted: Sun May 02, 2010 9:34 am
by Screwy
Do u run 3 slider mounts as pictured or is there a 4th one at the back?
If there is a 4th one where do u mount it???
screwy
Posted: Sun May 02, 2010 9:52 am
by Clarkie
Screwy wrote:Do u run 3 slider mounts as pictured or is there a 4th one at the back?
If there is a 4th one where do u mount it???
screwy
4 mounts
Posted: Sun May 02, 2010 5:51 pm
by familybus
i thought welding to the chassis was a no no?
Posted: Sun May 02, 2010 6:46 pm
by Clarkie
vehicle has full cert(inc sill cut,sliders,lift,drop boxs,lenghtened susp arms/panhards etc)I spoke to engineer before fitting sliders.
Could be different in Oz though
Chassis is made of 2 sections welded togeather from factory,(not the best welding either)
Cheers Shane
Posted: Sun May 02, 2010 6:50 pm
by hokey
welding to chassis is alright but shouldn't rally be done lIke above. should use a diamond shape plate so there's no vertical welds as they creat stress fractures and can crack
Posted: Sun May 02, 2010 6:53 pm
by zer0
familybus wrote:i thought welding to the chassis was a no no?
in queensland it is a no no i cant say for the other states but i would assume they are the same .... u can try and get it certified here but unless you got big bucks to have your chassis x rayed etc u will need to bolt it on as for the one you see it is in new zealand and i have no idea about their rules
cheers
Heath
--Zer0--
Posted: Sun May 02, 2010 7:39 pm
by Screwy
zer0 wrote:familybus wrote:i thought welding to the chassis was a no no?
in queensland it is a no no i cant say for the other states but i would assume they are the same .... u can try and get it certified here but unless you got big bucks to have your chassis x rayed etc u will need to bolt it on as for the one you see it is in new zealand and i have no idea about their rules
cheers
Heath
--Zer0--
its ok to weld to a chassis in NSW and VIC.
QLD is anal with engineering....
Rememeber, you can SOA and have large lift in VIC and NSW. You cant in QLD.....
Screwy
Re: Anyone done sill chop on gq
Posted: Mon Aug 01, 2011 6:52 pm
by steve patrol
Anyone done this in qld?
Cheers
Steve
Re: Anyone done sill chop on gq
Posted: Sun Aug 07, 2011 1:13 am
by AllTorqueGQ
A few boys up here in Queensland are cutting the sill slightly higher and replacing the whole sill with a piece of 100x50x3-5mm box section and not running sliders
Re: Anyone done sill chop on gq
Posted: Mon Aug 08, 2011 11:23 am
by steve patrol
Sweet. I ended up using 6mm plate. But cut it slightly higher like you are talking about. 4mm gap under the door to the plate right through...
Cheers for the help