Outer Limits 4x4 Board

bent the gear shifter if nessecary in the vice

with the transfer i dont think ou will need to bend it.

with my 3 inch body i can shift into 4 low but it wants to pop out due to the rubber boot

so all i do is remove the 4 screws when using 4 low

have unbolted the body and jacked it up off the chasis. have noticed there are some other mounts that touch the body but are not bolted. there is rubber pad between them. do i need to put spacers in these positions?

no its not nessecary they are just rests

built4thrashing wrote:have unbolted the body and jacked it up off the chasis. have noticed there are some other mounts that touch the body but are not bolted. there is rubber pad between them. do i need to put spacers in these positions?

for these spots, i used RHS and glued it it with rubber on each side.