Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
2nd t case in duals overheating
Moderators: toaddog, Elmo, DUDELUX
hypolux wrote:wot has the splines got 2 do with it ?? if they needed grindin off u woodnt b able 2 bolt the 2 cases 2gether right ??
Look at the Picture Scott posted. That is a late style input shaft. The early style had a full spline rather than just half as pictured. But where the new style finishes the spline the early style has a slight step up in it so you need to machine down about .5 of a mm off the outside of the spline where it steps up.
RUFF wrote:hypolux wrote:wot has the splines got 2 do with it ?? if they needed grindin off u woodnt b able 2 bolt the 2 cases 2gether right ??
Look at the Picture Scott posted. That is a late style input shaft. The early style had a full spline rather than just half as pictured. But where the new style finishes the spline the early style has a slight step up in it so you need to machine down about .5 of a mm off the outside of the spline where it steps up.
r ok then i wasnt aware of this
so is the older inout stronger coz of this
HYPOFAB
Thanks to:
Polyperformance
Yuri 4x4
Longfield
Thanks to:
Polyperformance
Yuri 4x4
Longfield
Who is online
Users browsing this forum: No registered users and 24 guests