Outer Limits 4x4 Board

i cut down a drivers side door, folded a lip on the cut edge and riveted soft sheet tin/aluminium. droopypete might have some pics.

don't cut your hinges. just replace the screws with hex head bolts. if you can't undo the screws, apply direct heat to break the thread locking glue.

Mudzuki wrote:Bigsteve, from the pic it appears that you cut about 10mm above the crease on the door skin, is this correct?

Like the idea of c channel as it covers up the dodgy grinding work

I cut right on the high side of that crease, the C channel sat slightly higher