Page 2 of 2
Posted: Tue Nov 19, 2002 10:02 pm
by bubs
why not tony?
does that mean the pajero rotors will not fit on to the IFS housing?
Posted: Tue Nov 19, 2002 10:15 pm
by RUFF
Not for $450 a side i wont
You have to machine the centre out and they will fit.
Posted: Tue Nov 19, 2002 10:24 pm
by bubs
oh for that reason - thats cool run spacers in stead or nothing at all?
Posted: Tue Nov 19, 2002 10:29 pm
by RUFF
Not knocking Richard in anyway as i know what is involved in making these spacers and they would have to be worth every cent.
In any case i could not run them on the front anyway as if i was any wider i wouldnt be able to turn full lock full compresion with out major rubbing.
Posted: Tue Nov 19, 2002 10:33 pm
by bubs
RUFF wrote:Not knocking Richard in anyway as i know what is involved in making these spacers and they would have to be worth every cent.
In any case i could not run them on the front anyway as if i was any wider i wouldnt be able to turn full lock full compresion with out major rubbing.
]
thats cool
Posted: Wed Nov 20, 2002 12:48 am
by hophoar
RUFF wrote:Not for $450 a side i wont
You have to machine the centre out and they will fit.
What do you mean?
Posted: Wed Nov 20, 2002 7:27 am
by RUFF
What do you mean what do i mean??????
Posted: Wed Nov 20, 2002 2:55 pm
by bj on roids
$900 for 3" of width?
ummm...no thanks
in fact that will almost buy you a rockwell, how much width will that get you?
farkin heaps!!
Posted: Wed Nov 20, 2002 4:05 pm
by hophoar
Ruff, What do you mean about having to machine the centre? was what I wanted to ask
Posted: Wed Nov 20, 2002 7:37 pm
by cplux
got my front done, spacers made by local engineering shop for around $600 all up incl nuts bolts etc. Great conversion i gained alot more wheel travel. there isnt really that much thinking involved, for me it was more of a problem convincing people it would work.
Posted: Wed Nov 20, 2002 8:45 pm
by RUFF
hophoar wrote:Ruff, What do you mean about having to machine the centre? was what I wanted to ask
Yeah no worries i was replying to Bubs's question about my rear disks and i had to machine the centre out of the disk rotor to fit over the end of the axle.
Posted: Thu Nov 21, 2002 10:43 pm
by Pal
Try this link for a picture of the front hubs.
http://www.frii.com/~frorfab/wide.html
Posted: Fri Nov 22, 2002 7:10 am
by Wendle
cut the mount off the top of the chassis and move it to the side of the chassis rail so that it is pointing down.. Same effect as having an extra ~150mm of brakeline.