Page 2 of 2
Posted: Mon Nov 28, 2005 3:19 pm
by gone fishin
I'm considering an RB 30 engine transfer into mine, as I want to stay under 3.3L for winch challenge, and am thinking of running the VL auto box and divorsed t/fer, Can you get rock hopper gears for MQ/K divorsed transfers, I was also going to have my gearbox and t/fer nearly touching each other, is there any reason why you have them about 1 foot apart, was it easier to get a shaft to join them this way, I'm looking at doing this to my shorty after the rear diff gets moved back and coil conversion done, this should give me a bit more room.
Posted: Mon Nov 28, 2005 3:21 pm
by Screwy
no you cannot get rock hoppers for MQ/MK tranfers
Posted: Mon Nov 28, 2005 3:24 pm
by Wendle
Screwy_ScrewBall wrote:no you cannot get rock hoppers for MQ/MK tranfers
actually, i think you can. the TX10A calmini kit should be a goer. someone who knows more about MQ junk than me would have to confirm it though.
Posted: Mon Nov 28, 2005 3:28 pm
by Screwy
Wendle wrote:Screwy_ScrewBall wrote:no you cannot get rock hoppers for MQ/MK tranfers
actually, i think you can. the TX10A calmini kit should be a goer. someone who knows more about MQ junk than me would have to confirm it though.
To all counts of my knowledge, gearing is not available on MQ/MK transfers, trust me ive tried....
rockhoppers are definatly not a goer....
i have contacted marks in the past and they have said if i give them 10,000 and 5 transfers they will make some up playing with the first transfer as a doner....
and it would only end up with a reduction of about 35 percent.....
obviously i didnt bother
Posted: Mon Nov 28, 2005 4:00 pm
by Wendle
http://www.xterraparts.com/Merchant2/me ... creen=PROD
this kit is made for a nissan TX-10A t/case, which i think is the same animal as the MQ uses.
Posted: Mon Nov 28, 2005 4:07 pm
by Screwy
MQ married transfer is T130A
MQ divorsed transfer is T100
Posted: Tue Nov 29, 2005 5:55 am
by Wendle
Screwy_ScrewBall wrote:MQ married transfer is T130A
MQ divorsed transfer is T100
oh well. put an atlas in it.
Posted: Tue Nov 29, 2005 6:02 am
by V8Patrol
Screwy_ScrewBall wrote:MQ married transfer is T130A
MQ divorsed transfer is T100
I wonder how hard it would be to addapt the MQ gearbox to take a TX-10A transfer.....
If only I had a TX-10A layin around I'd give it a go
