Outer Limits 4x4 Board

hey fellas..

doing a removal and refit of the injectors on my 3b (swapping reco'd injectors between two 3b's)..

and I have been advised by the fellows on ih8mud that I need a Super Deep 27mm socket to get the injectors out..

I have rung around a few places but without much luck (superheap/repco/aussie auto)..

can anyone recommend where I could find one of these? or even loan one?

cheers!

associated ih8mud thread here: http://forum.ih8mud.com/showthread.php?p=1855127

I've always just used a 27mm ring spanner.

Have a look here mate. www.snapontools.com.au

Cheers Mick.

What about a tube spanner

picked up a ring spanner from superheap for $20.. repco wanted $40..

how will I torque them on again though? should be good if i try my best with a spanner?

thanks for your suggestions anyway..

shorty_f0rty wrote:picked up a ring spanner from superheap for $20.. repco wanted $40..

how will I torque them on again though? should be good if i try my best with a spanner?

thanks for your suggestions anyway..

$20 for one spanner hole moly moly moly moly moly

tube spanner would be the go, weld an old socket to the back of a tube spanner and you would be able to torque it up.

shorty_f0rty wrote:picked up a ring spanner from superheap for $20.. repco wanted $40..

how will I torque them on again though? should be good if i try my best with a spanner?

thanks for your suggestions anyway..

Just do 'em up FT.