Page 1 of 1
twin transfer cases for gq
Posted: Sun Feb 18, 2007 10:48 am
by offroader-rama
whats involved for twin transfer and would low range rock crawler gears be good enough
Re: twin transfer cases for gq
Posted: Sun Feb 18, 2007 11:06 am
by 80lsy gq
offroader-rama wrote:whats involved for twin transfer and would low range rock crawler gears be good enough
would be cheaper to get transfer gears done
with twin transfers you need to change the following..
front tailshaft (two piece shaft running a centre bearing)
rear shaft (needs to be shortened)
new transfer case mount to support the rear transfer
if you have an auto you will need to modify the linkages you get with the twin transfer adapter
cut holes in your floor for the new gearstick..
add to that the cost of buying the transfer case adapter and it is pretty exxy..like prob around the $2500 mark depending on what you can do yourself (that includes having to get another transfer case as well)
crawler gears in your transfer case will cost around $1500 fitted
dave
if you do wanna go the twin transfer still i have a transfer here for $200
Posted: Sun Feb 18, 2007 12:27 pm
by hiluxv8
Posted: Sun Feb 18, 2007 12:45 pm
by A1
This setup has come out of a Rocky which was running the infinity V8 ....and so on ....so all the crossmembers and other work will be needed plus the coin for the front shaft .....and rear
I ran Marks gears in My Mav ....with 37"s 4.8 diff ratio's ......most of the time I just used second gear as 1st you just could get the wheelspeed when needed......and it was still low enough to crawl in second ......this was a diesel aswell
just go the gears you wont be disapointed ....
unbolt fit the gears bolt back in hey presto no fawking around ....
Dan
Posted: Sun Feb 18, 2007 8:24 pm
by offroader-rama
thats what i thought twin transfer a lot of dicking around for little does any one know a good place to get rock crawler gears fitted south side brissy, I'll remove / refit the transfer need two transfers cases done.
Posted: Fri Dec 28, 2007 8:02 pm
by DIRTY ROCK STAR
other then hiluxs what is a good centre bearing to be running on this setup?
and yeah it was me who bought that dual case setup.
im hoping to have the whole thing sorted with the shafts etc made up for about 1400ish.
Posted: Fri Dec 28, 2007 10:45 pm
by 80lsy gq
DIRTY ROCK STAR wrote:other then hiluxs what is a good centre bearing to be running on this setup?
and yeah it was me who bought that dual case setup.
im hoping to have the whole thing sorted with the shafts etc made up for about 1400ish.
go to your local bearing place and get a P208 saddle and an inner bearing UC 208.....i used it on Bartsos truck and it is also what i use in the buggy..fits a 60 series shaft
dave
