Outer Limits 4x4 Board

hey guys

can the back of a gearbox that is from a divorced transfer\gearbox setup be un bolted and put onto a gearbox that was a joint transfer\gearbox??

or are they totally different gearbox's??

just wondering as i would like to be able to make my 5 speed into a divorced setup and use a transfer from a different truck.

not sure if its feasable but need the mq guru's out to let me know.

thanks

mike

yes

But will the threaded portion on the back of the mainshaft prevent the driveshaft yoke from fully engaging the splines? I suppose it could be cut off

Woop wrote:But will the threaded portion on the back of the mainshaft prevent the driveshaft yoke from fully engaging the splines? I suppose it could be cut off

i have tried a couple of different combinations that worked ok....
not to say that all do.... some might have a different length output shaft...

try it and see....

screwy