Page 1 of 1
Six point cage for 4 door
Posted: Sun Feb 25, 2007 2:06 pm
by ratrangie
Where have people got these from and how much will fit it myself .
regards Stu..
Posted: Sun Feb 25, 2007 4:23 pm
by 6.5 rangie
Most cages are built in the car and welded in, pretty sure you couldn't get a bolt in kit (diy). Try Browns Davis as i think their cages bolt together
Posted: Tue Feb 27, 2007 11:57 am
by schuler
Got to agree with 6.5 rangie, i had mide done at Malvern Motorsport, they were doing the cage for brockies FX Goodwood car at the time, check out the pics in "Post your rovers" Mark the fabricator is a genious, can't recommend them highly enough.
Steve
Posted: Tue Feb 27, 2007 5:36 pm
by shakes
mind giving a rough $$$ figure?
Posted: Tue Feb 27, 2007 6:52 pm
by 6.5 rangie
Around $2k, yours would be a bit less being a ute
Posted: Wed Feb 28, 2007 8:15 am
by schuler
Yeah, mine cost me around the 2K mark, etch primed but unpainted. we had a lot of discussion about design, to ensure the cage didn't impede access to the accelerator (can't have that) i was originally going to have a diagonal brace above the drivers head but issues with vic roads made me decide on a single brace in the middle of the vehicle. Malvern Motorsport do alot of historic touring cars and rally cars, however Mark used to work for ARB and has a good understanding of what we 4WD's need.
Steve
Posted: Wed Feb 28, 2007 8:43 am
by Tiny
bond roll bars, fully bolt in units will freight anywhere at the right price, they make heaps of cages for supercars, rally and other race application and heaps to mines etc though out asia
Posted: Wed Feb 28, 2007 9:41 am
by mickrangie
can i get a number for Malvern Motorsport......
Posted: Wed Feb 28, 2007 11:42 am
by schuler
mickrangie wrote:can i get a number for Malvern Motorsport......
Hi mickrangie,
You can contact them on 1300 72 66 54
Check out their web site
http://www.malvern-group.com.au/
Cheers
Steve