Page 1 of 1
Help asap - can't get gearbox back in
Posted: Fri Mar 02, 2007 5:01 pm
by joeyree
we can't get gearbox to go on all the way is there a trick
gearbox ???
Posted: Fri Mar 02, 2007 5:12 pm
by want33s
If you are sure the clutch is aligned correctly, check the gap between the block and the bellhousing is EVEN, ALL the way around. Check there are no hoses or wires/cables in the way. There should be two dowel pins to line up, you may have to rotate box clock &/or anti-clockwise. ....not easy to describe a general purpose instruction when there are so many things that could be wrong. good luck!
Posted: Fri Mar 02, 2007 5:44 pm
by CHOPS1
No, i think he hasnt got the clutch plate aligned properly!
Did you use an aligning tool. so the spiggot will go into the spiggot bearing?
Chop
Posted: Fri Mar 02, 2007 7:27 pm
by MART
Put some grease on input shaft,works all the time,Cheers Paul.
Posted: Fri Mar 02, 2007 7:48 pm
by short stuff
you might find the spline needs turning a bit