Page 1 of 1
winch bar mounts
Posted: Sat Mar 03, 2007 7:59 pm
by maccasMQ
i'm talkin about the screw holes on the chassis where you put ya bull bar onto. Well, are these the same for MQ's and GQ's?
Posted: Sat Mar 03, 2007 11:41 pm
by maccasMQ
bump!
Posted: Sun Mar 04, 2007 2:04 pm
by bru21
no chassis are different widths, as for the bolt spacing I have no idea
Posted: Sun Mar 04, 2007 3:53 pm
by nastytroll
bolt hole design n spacing is completly different also chassis width is different but it is easy to make the new mounts for the gq/mq then cut the old ones of the bar n weld them on there is a difference in total width of bar as gq is slightly wider across the mudguards but its not overly noticable
Posted: Sun Mar 04, 2007 3:58 pm
by maccasMQ
i was talkin about a gq cheezy winch bar.
Posted: Sun Mar 04, 2007 4:52 pm
by nastytroll
If your fitting a gq cheezy bar to a mq n alredy have the bar sit it up near the chassis n c how it looks if you have to make new mounts its easy jus copy the mounts that are on the bar n drill holes to suit mq cut the bar n weld new ones on presto