Outer Limits 4x4 Board

I'm in the process of applying for approval for my bodylift and the paperwork requires a list of ADR's stamped on my compliance plate.

But there are none.

Unless I can't see a third plate there are no ADR's stamped onto the two plates I can see. Does anyone else have a third plate other then a mod plate or know appropiate ADR's. My Sierra is plated as being manufactured 10 - 95.

Greg

my 89 SWB WT Sierra has an alloy plate on the top of the firewall directly in front of the driver. It says:
THIS VEHICLE WAS MANUFACTURED BY THE SUZUKI MOTOR COMPANY HAMAMATSU JAPAN TO COMPLY WITH AUSTRALIAN DESIGN RULES,
1,2,3,4C,5B,6,7,8,11,12,14,15,16,18,20,22A,23B,24A,25A,28A,35A,40,43/01
SUZUKI SIERRA D UTE 1.3 SJ50 4/89 GVM 1340KG
VIN: JSAXXXXXXXXXXXXXX
MY plate is easy to read but if it were corroded or painted over you could have trouble seeing the feint stamping.

is this next to the blue factory plate? left or right, pretty sure mine doesn't have it.

About 4-5 inches from clutch cable,Cheers Paul.

I should have just posted pics to begin with!.