Page 1 of 1
Lex V8 and auto length
Posted: Wed Mar 14, 2007 4:37 pm
by jessie928
gidday guys,
has anyone got a 1uz and its origional auto lying around somewhere??
I need a length from crank pulley to output shaft
Cheers,
Jes
Posted: Wed Mar 14, 2007 6:00 pm
by jafa
I'll measure up tomorrow for ya
Posted: Wed Mar 14, 2007 6:57 pm
by jessie928
jafa wrote:I'll measure up tomorrow for ya
thanks bloke
JEs
Posted: Thu Mar 15, 2007 3:18 pm
by jafa
From front of crank pulley to the end of the 3 legged donut yoke thingy is 1355mm, note this is to the end of the yoke that is bolted to the output shaft, not to the rubber bit, mine has been taken off and is left with just the steel bit on the output shaft
Posted: Thu Mar 15, 2007 11:45 pm
by jessie928
jafa wrote:From front of crank pulley to the end of the 3 legged donut yoke thingy is 1355mm, note this is to the end of the yoke that is bolted to the output shaft, not to the rubber bit, mine has been taken off and is left with just the steel bit on the output shaft
sweeet, thanks man
Jes