Page 1 of 1
center console
Posted: Wed Mar 21, 2007 12:07 pm
by Pyrotech
Has anyone built/modified an centre console to fit in to a Suzuki sierra?
Any ideas?
-Pyro
Posted: Wed Mar 21, 2007 1:53 pm
by nicbeer
seen a couple ideas
Ammo box as per smilysmoke
I have two options for mine
i made a custom 6-9mm mdf wood one with padded top nice and deep. or
one of the $30 coolers from dick smith.
Can get pics if needed
Nic
ffd
Posted: Wed Mar 21, 2007 2:26 pm
by patzuki
I use the factory Jimny with the two cupholders, fits perfect
Posted: Wed Mar 21, 2007 3:56 pm
by hyzook
I acquired a Bestop one but found it didn't fit right and ended up using only the tray and hinge.
The tricky part is allowing the seat belts room so the seats can still slide
and the inside needs to allow the handbrake to come up.
Posted: Wed Mar 21, 2007 4:14 pm
by smiley_smoke
here is mine.. ammo box cost like 12 bucks from disposal store
cup holders were 3 or 6 bucks each from crazy clarks.. few rivets and a cut out of one of the cup holders to fit over the old grab handle that i ripped off the top of the box.. fits nice behind the handbrake
oh and i used the dremel to open up the hole in the clipdown bracket.
then put a u bolt with a few nuts and lock nuts through the front of the case.
now its lockable and water tight.. my mobile isnt swimming in the passenger footwell ever again!
Posted: Wed Mar 21, 2007 4:21 pm
by smiley_smoke
nicbeer wrote:seen a couple ideas
Ammo box as per smilysmoke
I have two options for mine
i made a custom 6-9mm mdf wood one with padded top nice and deep. or
one of the $30 coolers from dick smith.
Can get pics if needed
Nic
i bought one of those coolers as i gave my waeco cooler to my bro for his drive over east.. ill go check it out for measurements in the zook.. has cup holders also
Re: ffd
Posted: Wed Mar 21, 2007 4:46 pm
by =SKB=
patzuki wrote:I use the factory Jimny with the two cupholders, fits perfect
Got Pics?