Outer Limits 4x4 Board

Hi i just fitted a 4'' lift and was wondering how much longer to make front and rear panhards?

undo one end of the rods, push the body across to where u want it and measure to the center of ur bolt on points

how do you know if it is in the right place?
what do you measure? side to side
or do you go by eye?

by eye or get a straight edge up the sde of ur tyres and measure into a common point on either side of the car that way u can find where ur body is sitting in relation to your wheels and this will leave ur diffs ending up where they should be. then measure from the chassis mount to ur diff mount to get ur new rod length

Gday gqlwb I have 4" and the panhard length to centre of each bolt is 985 rear and 875 front roughly measured within a couple a mm hope this helps mine are adjustable and a workshop fitted so i assume this sould be correct length. correct me if i'm wrong anyone

micks troll wrote:Gday gqlwb I have 4" and the panhard length to centre of each bolt is 985 rear and 875 front roughly measured within a couple a mm hope this helps mine are adjustable and a workshop fitted so i assume this sould be correct length. correct me if i'm wrong anyone

yeah its a car buy car thing. find a common point and mesure from there.

the aim is to get the wheels central uner the car as i assume you've noticed one side hanging out!