Page 1 of 1
what size backspace
Posted: Tue Dec 02, 2003 6:32 pm
by suzidisco
Does any one know what size backspacing is required on a disco to run 34JT2 so that they have the full turning circle
What price should i expect to pay and who make coustom rims
preferr Sydney/Newcastle area
Posted: Tue Dec 02, 2003 7:33 pm
by DiscoDino
I run my 35ETs on 15x8 steelies with an equal offset of 4" in and 4" out on the front, and 4.5" in and 3.5" out on the rear.
Posted: Tue Dec 02, 2003 10:12 pm
by Fubar Paul
80mm all round
Posted: Wed Dec 03, 2003 11:30 am
by mickrangie
i have 95mm off set on my rangie and i still rub with my road slicks and rub a lot with my ET's
Posted: Wed Dec 03, 2003 12:24 pm
by Fubar Paul
80 mm offset,2" body ,2" spring lift .35" ET's no rubbing.
Posted: Wed Dec 03, 2003 12:43 pm
by mickrangie
DOH!
WTF is mine scrubin / rubing all over the shop?
Girls are getting excited when they sit in the back seat with the ET's on
Posted: Wed Dec 03, 2003 3:36 pm
by suzidisco
Looks like ill get 80mm offset
but how makes them at the right price.
Posted: Wed Dec 03, 2003 6:14 pm
by LOCKY
PM Me, or ring 03 9705 6677
Have new Steel US Built rims from 15x8 to 16x10 in stock
Jason
Posted: Thu Dec 04, 2003 1:52 am
by red90
I'm sure he means 80mm backspacing. 80mm offset would be really bad. Backspacing is preferably around 4".
Posted: Thu Dec 04, 2003 6:13 pm
by Slunnie
I understand back space is the distance between the rim edge and the machined mating surface in the center of the rim, though how does an offset measurement work
Posted: Fri Dec 05, 2003 2:49 am
by red90
http://www.rangerpowersports.com/tech/general/wheelandtire.shtml
It is always best to talk in terms of backspacing as this is what is critical.
Posted: Fri Dec 05, 2003 6:13 am
by Slunnie
Thanks Red90. That makes sence now.
Posted: Fri Dec 05, 2003 7:52 am
by Bodge
I have 0 offset and about 90mm back spacing - which I can say is not enough - but thats how it came... Another 20 -25 mm bs would make it perfect.
rims 15 X 9.5 Mac 5
Posted: Fri Dec 05, 2003 3:47 pm
by Rangee
I have a gold set of Mac 5's and they are 15 X 9.5
when i measeured for the off set i got the following measurements
rim edge to edge is 11 inches
inside rim edge to plate is 5 inches, so does this mean they are negative offset by 1/2 an inch ?
thanks if you can help