Page 1 of 1
fitting water cooled CT20
Posted: Tue Apr 17, 2007 2:31 pm
by Guy
My new turbo has arrived and it is truely a reco.. The thing is a bit newer than the one I removed and is water cooled.
Anyone have pics of how it is setup .. ( I have read few descriptions of how it works and cant seem to figure out how to do it properly)
Posted: Tue Apr 17, 2007 2:54 pm
by bigcam
i swapped my water cooled to non water cooled, there are some lines and bits, ill; see what i can dig out (most went to the tip though) or at least take some pics, it was a 2.4lt bundy though but should be the same.
will post tonight for ya
cam
Posted: Tue Apr 17, 2007 9:42 pm
by crack
when you say watercooled does it run water through from the radiator or do u mean it was running a intercooler? as i said in another post not a mechanical guru
cheers
jack
Posted: Tue Apr 17, 2007 11:28 pm
by Sic Lux
On mates dts one it taps into the heater hose near thermostat and the heater hose near firewall i think try get pic's tommorow night
Posted: Wed Apr 18, 2007 12:04 am
by Guy
crack wrote:when you say watercooled does it run water through from the radiator or do u mean it was running a intercooler? as i said in another post not a mechanical guru
cheers
jack
The bearing on the turbo is water cooled.
Posted: Wed Apr 18, 2007 1:31 am
by fisho64
just tap into the two heater hoses, but make sure it is on the engine side of the heater "off" valve, otherwise you will get no flow when the heater is off.
Posted: Wed Apr 18, 2007 8:20 pm
by Sic Lux
yeah thats how mates is done 100%