Page 1 of 1
help with winch
Posted: Wed Apr 18, 2007 7:55 pm
by 92mav
finally i have got some plasma for my high mount winch
and now it wont work properly on the hand controler. my in cab controls work fine
any help?
Brad
Re: help with winch
Posted: Wed Apr 18, 2007 8:58 pm
by TEAMRPM
92mav wrote:finally i have got some plasma for my high mount winch
and now it wont work properly on the hand controler. my in cab controls work fine
any help?
Brad
crook controller maybe!
is it a 5 or 3 pin solenoid setup?
Posted: Wed Apr 18, 2007 10:10 pm
by 92mav
checked that and all wiring to the controler with an ohm meter and all of it is ok . no crossed wires. no broken wires . the wired thing is it will sometimes go the same way no matter which way the switch is pushed that is on the hand controller not the in cab controller. i,m miffed
Brad
the controler only uses 3 wires
Posted: Wed Apr 18, 2007 10:23 pm
by tna racing
hey mate check the solioid box and run a multi meter across the circut as it should only b going 1 way
Posted: Wed Apr 18, 2007 10:33 pm
by 92mav
yes but if it were a problem with the solinoids i would not switch properly with either controles
Posted: Wed Apr 18, 2007 10:34 pm
by tna racing
yer maybe theres a ire loose in ur solinoid box to ur controller plug.just narrowing down the list