Outer Limits 4x4 Board

Carried a load of firewood for a couple of hundred kms across the Big desert a few weeks ago and a mate stacked the roof rack and a few logs made it through the roof rack bars and have rubbed down to bear metal on the roof in a couple of places.

I have since got a colour match and a pressure pack of the correct colour and a can of primer. I have never done any spraying touch ups before, but assumed it can't be that hard. Can anyone provide any tips on prepping the area that needs to be resprayed and the best method for respraying?

I'll be interested in this as i have Black GQ Maverick and were my orginal mud flaps were have rubbed back to the whte undercoat so this will be very handy

Rick.

assuming you don't need to fill...

get some fine wet and dry, cut back the area and a little around it.

wipe down with prepsol to remove dust and other contaminants.

if undercoat is still intact (ie no metal or rust) then mask off area and spray with long even strokes, triggerr on b4 you hit the painted area and trigger off after.

may have to layer, don't be tempted to spray too thick or will run.

Spock

now pls check with a panel beater to make sure i got it right....