Page 1 of 1
building spare wheel carrier for 60 series
Posted: Mon May 14, 2007 5:56 pm
by rowan
howdy- anyone got any pics or ideas of how to make a double swing-away rear wheel carrier using the stock rear bumber? i'm not sure if the steel is thick enough / strong enough. don't want to build a whole new rear bumber. was thinking of maybe bolting some flat bar to the underside of the top of the bumper and using that to support the outer hinge?
Posted: Tue May 15, 2007 8:45 pm
by Sixty's Guy
I'm pretty sure that 4wd Systems do twin wheel carriers for the 60.
Posted: Mon May 28, 2007 5:19 pm
by cruiser60series
a flat piece above and below the bar with bolt holes to match to bolts through the bar. You can weld a hinge onto these two plates. I bought a homemade job like this on ebay for 100. haven't put it on yet though. and obviously not a double
this is the pic from the ebay page
Posted: Mon May 28, 2007 5:27 pm
by grimbo
you could always just buy one of these
http://www.tiregate.com/hg.shtml
