Page 1 of 1
need help removing lifters - 3F 60
Posted: Mon May 21, 2007 12:18 pm
by borisr33
Hey guys,
Got a mate who is rebuilding his head and can’t seem to get the mechanical lifters out!
Doesn’t seem to be anything to grab then with! There is only the divot that the rod sits in. Even turning the cam shaft doest bring them high enough to get anything to wedge them out.
Any suggestions would be appreciated - have also included pic.
Thanks in advance!!!
Dom
Posted: Mon May 21, 2007 12:55 pm
by KaMo
A small, strong magnet on a stick?
Posted: Mon May 21, 2007 7:02 pm
by borisr33
thanks kamo....its hard to find a small strong magnet but will give it a try
Posted: Mon May 21, 2007 7:20 pm
by dogbreath_48
borisr33 wrote:thanks kamo....its hard to find a small strong magnet but will give it a try
Any decent tool shop will sell them in telescopic and flexible configuration.
Posted: Mon May 21, 2007 8:20 pm
by Modified Toy
you need a lifter removing tool
Posted: Mon May 21, 2007 8:29 pm
by RED60
If they're mushroomed on the bottom you mite hav a problem.
Posted: Mon May 21, 2007 8:34 pm
by Evil 73
Easiest solution is to burn the 3F boat anchor motor, i burnt mine!!!!
Ben
Posted: Mon May 21, 2007 9:23 pm
by borisr33
dogbreath_48 wrote:borisr33 wrote:thanks kamo....its hard to find a small strong magnet but will give it a try
Any decent tool shop will sell them in telescopic and flexible configuration.
will see what they have cheers
Modified Toy wrote:you need a lifter removing tool
i have seen lifter removing tools for hydrolic lifters but not mechanical...any more info on this???
RED60 wrote:If they're mushroomed on the bottom you mite hav a problem.
they are slightly mushroom shaped but with a divot in the middle that the push rod locates in......hhmmm
Evil 73 wrote:Easiest solution is to burn the 3F boat anchor motor, i burnt mine!!!!
Ben
Hey Ben that must of been a sight. How did you manage that?
Though I don't think my mate will go for this one.....