Page 1 of 1
Snake Hysteer
Posted: Wed Dec 25, 2002 8:59 pm
by bubs
Ok i need some one to meausure the length between the TRE's on a hilux set up with snake hysteer
This is because i want to put on a 4x4 Engineering Tie Rod - but if i can - i want to run a 35mm rod with 80series TRE's and clamp the stabiliser on for now until i eventually go hysteer - so i dont have to buy 2 tie rods
I can't see any reason why they would be much different if different at all.
Buddy
Posted: Thu Dec 26, 2002 9:36 am
by hophoar
Hey bubs, I don't exactly know what your trying to run with the 4x4 engineering tierod, but from what I think your trying to do is crossover with flipped arm then the tierod lenght should be about the same lenght give or take abit, so one should fit the other. The big difference is in the drag link with it being inline on the hysteer arms as opposed to the flipped arm.
Posted: Fri Dec 27, 2002 9:40 am
by bubs
I want to use a 35mm tie rod with standard steering - sorry for confusing you
Posted: Mon Jan 06, 2003 5:46 am
by Zol
The tierod itself is 38 inches in length & the distance between the centre of the mounting points including the TRE's is about 43 inches...give or take wheel allignment.
Is that what you were look for?
Posted: Tue Jan 07, 2003 9:51 pm
by bubs
Zol wrote:The tierod itself is 38 inches in length & the distance between the centre of the mounting points including the TRE's is about 43 inches...give or take wheel allignment.
Is that what you were look for?
exactly what i was after
Posted: Wed Jan 08, 2003 12:35 am
by Zol
bubs wrote:Zol wrote:The tierod itself is 38 inches in length & the distance between the centre of the mounting points including the TRE's is about 43 inches...give or take wheel allignment.
Is that what you were look for?
exactly what i was after
And there goes another......Happy....customer..... 8) :wink:
