Outer Limits 4x4 Board

Hi Alll

I have a problem with my Zook.

I have a vibration driving right across the rev range. When not in gear idles ok but when in gear i feel a bad vibration when driving. Gearing down I can feel it. Makes me think it is a clutch problem. Clutch is not slipping thou! If it was the diff or drive line it should do when rolling not in gear.
Any ideas, Suggestion would be great

Cheers
JacZook

Check all the mounts on the driveline , When rolling there is no torque to flex mounts , also when did it start and where did it start , Cheers Paul

Have a good look at all your uni's.

unis + tailshaft in phase.
i had that issue with my old zook. was partly uni joints and my tailshaft was out of phase.. only by a few splines but enough to shake the jibbers out of me and the zook.

MART wrote:Check all the mounts on the driveline , When rolling there is no torque to flex mounts , also when did it start and where did it start , Cheers Paul

x2

Specially the rear gearbox mount. The bolts can pull through and flog around when under load.

Make sure you check your jackshaft uni's too.