bottom hose on GQ
Posted: Tue Jun 19, 2007 8:11 pm
after lifting the body 2in my bottom radiator hose has a small kink in it, what can i do to fix this,,, has anybody else had the problem
thanks guys
thanks guys
Page 1 of 1
bottom hose
Posted: Tue Jun 19, 2007 8:24 pm
hi i take hose off turn around 180 degrees and trim to suit
Posted: Tue Jun 19, 2007 8:36 pm
Yeah, just cut a bit off the end
Posted: Tue Jun 19, 2007 10:35 pm
i had to trim about an inch off each end for mine then jam the bugger back on there
(for a tb42)
(for a tb42)
Posted: Tue Jun 19, 2007 11:59 pm
I havent done anything for my one yet,doesnt overheat so if it aint farkd dont fix it 
just havent bothered yet only been2 months.
just havent bothered yet only been2 months.Posted: Wed Jun 20, 2007 5:58 pm
i didn't bother with mine. and its been about a year and no probs
Posted: Wed Jun 20, 2007 6:05 pm
I bought a supercheap corrugated hose, that allows it to bend on the corrugations, and the hose itself also contains a coil to prevent crimping it.
It cost like $9 or $13 or something. Not expensive, and has done the job really well. But my bend was caused by an Aussie Desert Cooler radiator and not by a lift kit, so not 100% sure it will help you.
It cost like $9 or $13 or something. Not expensive, and has done the job really well. But my bend was caused by an Aussie Desert Cooler radiator and not by a lift kit, so not 100% sure it will help you.