Outer Limits 4x4 Board

Does anybody know how to de-activate the T BELT symbol off the dash on a HZJ 105 --- 100 series cruiser........

Yes..ask Greg (hdj105) or visit www.lcool.org

1. T-BELT MODE DISPLAY

a) With ignition turned ON, using the trip switch (select/reset button) change the display to ODO, and turn the ignition OFF


b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.


c) Release the trip switch, then press the switch again within 5 seconds.


d) The digital display should change to T-belt mode. The initial display "15" (0,000km) is displayed (ie. 150,000km).



2. REWRITING REPLACEMENT VALUES


While in the T-Belt mode, each press of the trip switch will change the displayed value by 10,000km increments. Once " 20 " (200,000km) is reached the display reverts back to " 1 " (10,000km) again. Remember, this setting is the number of kilometres to be travelled before the light comes on next, and once reset this counter will start from zero.


I believe the timing belt interval for all the 100 series engine variants is 150,000km, but this should be checked against each different markets servicing recommendation. This being the case, you shouldn't need to change from the default setting of "15".


Obviously for the US, the ODO is in miles, and I guess the T-Belt warning would be set in 10,000 mile intervals.



3. T-BELT WARNING RESET COMPLETION


a) After setting the replacement setting value, hold the trip switch ON for more than 5 seconds then release the switch.


b) Check that the display has now changed back to ODO and that the warning light has gone off when the engine is started.


NOTE: If the T-Belt mode is completed, even though the belt replacement has not been performed, the T-Belt warning IS reset.


I hope this proves to be of assistance guys, as usual all care no responsibility. ;-)

thanks for that will give it a go .... Thought I would post it on here first before asking Greg!!!

Thats straight off tech pages of www.lcool.org

YEP have done that to the ODO/TRIP display -talking bout the bright orange warning symbol" T-BELT"on the Tacho cluster!!!!!

My instructions above should have turned that off!

Yep, worked for me when I did it.

thanks Guys will try it again Im now 180,000 and the ODO 150K thing disappeared should the TBELT thing still work ?