Page 1 of 1
East-west G13BA engine
Posted: Sun Jun 24, 2007 11:47 am
by CHOPS1
Is there any difference between an east west g13ba and the one in my sierra besides the angled dizzy?
I cant see any.
Cheers
Chop
Posted: Sun Jun 24, 2007 12:59 pm
by Santos
-waterpump & pulley
-Sump and oil pick up
-Oils dipstick
-Intake and exhaust manifold
All of them obtainable from old motor except the water pump pulley if it's multigroove, then you can get one from a vit from the wreckers for approx $20
Posted: Sun Jun 24, 2007 1:43 pm
by CHOPS1
cool. yeah i meant motor wise. I will be getting it accesssory free just the engine no bolt on stuff included.
Chop
Posted: Sun Jun 24, 2007 2:38 pm
by Santos
motor wise just compression
9.5:1
havent pulled apart a sierra g13ba but the big difference (other than crank) in a short block g13ba from a swift and a g13a sierra engine is the rods where thicker in the sierra and the domes of the piston flat top on the swift. Both cranks weighed about 8.6kg
was this what you wanted to know?
Posted: Sun Jun 24, 2007 6:57 pm
by ZOOK60
And the cam will be different
Posted: Sun Jun 24, 2007 7:26 pm
by CHOPS1
ZOOK60 wrote:And the cam will be different
Are you saying the cam is different from the g13ba in my sierra to the g13ba barina/swift i'm getting it from?
Chop
Posted: Sun Jun 24, 2007 8:03 pm
by muppet_man67
you have to swap the cam to fit your dizzy as the gear that drives the dizzy is different.
Posted: Sun Jun 24, 2007 8:05 pm
by CHOPS1
Sorry, knew that
. thought he meant it was different in settings.
cheers guys.
chop