Page 1 of 1
transfer case stick slipping out
Posted: Thu Jun 28, 2007 8:47 pm
by cambo au
i have a 92 single cab hilux every now and then if i am changing from 4wd low or high the lever pops from between the two rods inside the box i have to stop take the boots of undo the top of the box slide one of the rods back put the lever back in and its all sweet is this a comon problem or is there something going on i cant see
thanks in advance
chris
Posted: Thu Jun 28, 2007 10:53 pm
by Sic Lux
mine does this was going to pull mine out and measure it compaired with a mates one or just go to the wreckers and get another or possably weld and grind it back to what it should be.
Posted: Thu Jun 28, 2007 11:38 pm
by ausyota
Tis a common problem.
Mine did it.
I just took out the transfer shifter and MIGed the end a bit and ground it square and it is all good again.
Posted: Sat Jun 30, 2007 7:01 am
by Sic Lux
ausyota wrote:Tis a common problem.
Mine did it.
I just took out the transfer shifter and MIGed the end a bit and ground it square and it is all good again.
sweet found something to do on weekend it was realy starting to s
t me
Posted: Sat Jun 30, 2007 11:17 am
by cambo au
thanks guys i will get on to it it has only done it a few times but that is enough