Cage mount to floor
Posted: Thu Jul 05, 2007 9:59 pm
What size mounting plate to you have to run for comps with internal cages.
Page 1 of 1
Posted: Thu Jul 05, 2007 10:03 pm
CAMS is steel plate of no less than 30x30x6mm per bolt...
Posted: Fri Jul 06, 2007 12:25 am
It varies from point to point, for e.g A+B pillar mountings minimum requirement is 100x100x3mm (15,000mm2) and rear stays is 80x80x3mm (6000mm2) this is for vehicles that weigh over 1151 kg and its also the specs for an internal cage, this meets ccda and cams specs.
Ben
Ben
Posted: Fri Jul 06, 2007 10:18 pm
Im pretty sure it is 100 x 150 mm for a and b pillar and 100 x 120 mm for rear stays . better check the ccda website .Evil 73 wrote:It varies from point to point, for e.g A+B pillar mountings minimum requirement is 100x100x3mm (15,000mm2) and rear stays is 80x80x3mm (6000mm2) this is for vehicles that weigh over 1151 kg and its also the specs for an internal cage, this meets ccda and cams specs.
Ben
Posted: Sat Jul 07, 2007 2:06 pm
Yeah ya better.....bagsy wrote:Im pretty sure it is 100 x 150 mm for a and b pillar and 100 x 120 mm for rear stays . better check the ccda website .Evil 73 wrote:It varies from point to point, for e.g A+B pillar mountings minimum requirement is 100x100x3mm (15,000mm2) and rear stays is 80x80x3mm (6000mm2) this is for vehicles that weigh over 1151 kg and its also the specs for an internal cage, this meets ccda and cams specs.
Ben
Ben
Posted: Sat Jul 07, 2007 7:06 pm
Evil 73 wrote:Yeah ya better.....bagsy wrote:Im pretty sure it is 100 x 150 mm for a and b pillar and 100 x 120 mm for rear stays . better check the ccda website .Evil 73 wrote:It varies from point to point, for e.g A+B pillar mountings minimum requirement is 100x100x3mm (15,000mm2) and rear stays is 80x80x3mm (6000mm2) this is for vehicles that weigh over 1151 kg and its also the specs for an internal cage, this meets ccda and cams specs.
Ben
Ben
Wondering how you came up with the mm2 calcs??
they dont seem to add up?? am i missing something?
cheers
DRS
Posted: Sat Jul 07, 2007 10:40 pm
Yeah mate I checked it ......My cage is ccda approved . Is yoursEvil 73 wrote:Yeah ya better.....bagsy wrote:Im pretty sure it is 100 x 150 mm for a and b pillar and 100 x 120 mm for rear stays . better check the ccda website .Evil 73 wrote:It varies from point to point, for e.g A+B pillar mountings minimum requirement is 100x100x3mm (15,000mm2) and rear stays is 80x80x3mm (6000mm2) this is for vehicles that weigh over 1151 kg and its also the specs for an internal cage, this meets ccda and cams specs.
Ben
Ben
