Outer Limits 4x4 Board

Hey Guys,

I'm looking at doing a 3" Bodylift but don't want to cut the floor.

Has anyone welded a 3" extension into their gear stick and transfer case levers.

Whats the best way to do it.

Regards

MD

why 3"? little high isnt it?

dont do it.
its nothing but a hassle to manythings need modding, its illegal and will make your cog high as
every one i have ever known to do a 3 inch has regretted it.

ps get friendly with your grinder instead:)

or make up the height with spring lift

j-top paj wrote:why 3"? little high isnt it?

Its a shorty and the winch bar and rear bar I have has already been modified to 65mm lift blocks.

Too much mucking around with getting these re-cut and welded.

Looking at a 3" Body Lift and 3" Spring Lift.

Regards

MD

I rebent mine with the oxy in a vice.... get a bucket of water and get ready to quench it quickly. (gear stick)

I have seen gear stick extensions but cant remember where..

for the 4wd\2wd cut the slot longer and be done with it..

It has to be engineered in nsw $$$$

cheers smitty

Yeah, Got my LWB Engineered late last year.

Will plan to do the same with this one.

Will be putting the body lift in this weekend.

MD

My advice is don't do it as it is only a matter of time until the cab cracks around the mounts and probably even tears out (particularly radiator support panel) .

shorties crack the front mounts standard also rear mounts