Page 1 of 1
1hz crank removal?
Posted: Thu Jul 12, 2007 7:13 pm
by bushwalker
got a flogged out woodruff key on my crankshaft that needs milling on a hzj75. how do i get the crank out?
Re: 1hz crank removal?
Posted: Thu Jul 12, 2007 7:56 pm
by heathhoppy
bushwalker wrote:got a flogged out woodruff key on my crankshaft that needs milling on a hzj75. how do i get the crank out?
hi bud pull the engine out and get into it and dont be scared, i think you can just pull the crank out with out taking the head but not 100 %shore good luck and have funn
Posted: Thu Jul 12, 2007 10:49 pm
by dogoff
Yes you have to remove the engine, but you dont need to remove the head.
The main bearing are a matrix system ie all joined together, you have to reseal this once you are putting it together.
Also there is a o ring between the two, if you dont put this in you will have no oil pressure
I can be easier to remove the cam shaft
Posted: Fri Jul 13, 2007 7:22 pm
by Gazza the Chippy
All I can say is thank god its not just me! Mine did the same thing, take motor out, put in second hand good one, new big ends and bearings while I was at it. Goes great since not a prob. Didn't have to pull head off either. Gazza!
Posted: Sat Jul 14, 2007 5:11 pm
by dow50r
a few motors complete on ebay...turbo diesel aswell....mmmmmmm