Page 1 of 1
How wide are you and How tall?
Posted: Mon Dec 30, 2002 6:10 pm
by RUFF
Ok just measured my rig before i start pulling it apart.
Currently i am
78"/1980mm wide on the Front
82"/2085mm in the rear
Measured from the very outside edge of the tyre.
And i am
80'/2030mm Tall measured at 4psi on 38.5/16/15 Claws.
How tall and wide are you?
Posted: Mon Dec 30, 2002 6:16 pm
by NICK
what is your frame height?
Posted: Mon Dec 30, 2002 6:21 pm
by NICK
front is 1820 from outside to outside on tyres
where the roof joins the cab (heightest point) i am 1900 and ground to chassis is 650mm at the gear box x-member.
now convert that to feet and inches
NICK
Posted: Mon Dec 30, 2002 6:49 pm
by RUFF
Im only at 21"/535mm to the X member. Are you sure yours is that much higher?
Posted: Mon Dec 30, 2002 6:50 pm
by RUFF
Is that the lowest point of the X member?
Posted: Mon Dec 30, 2002 7:06 pm
by 12uke
Specs for a Vitara wagon
1730mm(68inch) rear
1670mm(66inch) front
1800mm(71inch) high
Stock Vitara hight 1660mm
For a small 4by and a SUZUKI
Posted: Mon Dec 30, 2002 8:34 pm
by Cheezy4x4
ATM my POS is about 500mm to the highest piont and from the widest points around 1100mm.
Posted: Mon Dec 30, 2002 8:39 pm
by GRUNTLESS
my pos
roof height 2200mm WAY TO HIGH
front 1800mm WAY TO NARROW
rear 1850mm
x member 625mm
I THINK ITS TIME TO DROP IT
3 inchs any way
Posted: Mon Dec 30, 2002 9:42 pm
by big red
mines 2130 high and 2115 wide with 10.5r 35 centipedes
2970 wheelbase.
1605 front track.
1625 rear track.
its a GU ute
Posted: Mon Dec 30, 2002 10:12 pm
by JK
GRUNTLESS wrote:my pos
roof height 2200mm WAY TO HIGH
front 1800mm WAY TO NARROW
rear 1850mm
x member 625mm
I THINK ITS TIME TO DROP IT
3 inchs any way
Yeah mate, rip out that body lift for starters, you still have a long way to go before you have to worry about tyres scrubbing in your guards.
How's the old freckle after the Fred's run?
Posted: Tue Dec 31, 2002 9:34 am
by bj on roids
i am pretty tall
nev is pretty wide
Posted: Tue Dec 31, 2002 9:47 am
by Damo
bwaaahahahhaa, too funny
I hope Nev doesn't read this sh1t
Posted: Tue Dec 31, 2002 11:14 am
by bubs
1820 wide - standard axles - 12.5in wide MT/Rs - 2in BS rims
1840 high to snokle - highest point on mine
470 to lowest point on x - member
Posted: Wed Jan 01, 2003 11:27 am
by NICK
RUFF wrote:Is that the lowest point of the X member?
nar thats to the frame in the middle of the truck next to the cross member.
NICK
Posted: Wed Jan 01, 2003 1:02 pm
by drunkenperformance
520 to center of x member (std member), 1928 top of cab, not inc bar lights etc, track is std with 35 x 10.5 peeds, wheel base 2790
Posted: Thu Jan 02, 2003 6:07 am
by OVERKILL ENG
Width front and rear 1900mm
Height to crossmember 620mm
Wheel base 104 inches
Overall height.1900mm
HAPPY NEW YEAR TO EVERYONE
Posted: Thu Jan 02, 2003 6:58 am
by suprasurf
1900 high
1800 across rear
1750 across front
Thought about lifting the toy some more but not sure about the best height for the surf.. ramp over vs tip over
will prob play with a better xmember, don't really like to much weight too high
couldn't help notice, I think, is was gruntless... its sooooo high, that looks scary ??
Posted: Thu Jan 02, 2003 8:21 pm
by Cheezy4x4
Did a temp fit together today, and Im not to tall, not to wide and my wheelbase is how far apart my wheel hubs are.
..
Posted: Thu Jan 02, 2003 10:45 pm
by hypo
nice comments mark not giving 2 much away there keep us guessin
Posted: Fri Jan 03, 2003 6:23 am
by JK
hmmm... now lets see. (flipping to page 7 of the Gregory's Patrol/Maverick service & repair manual...)
tall = 1,750mm
wide = 1,800mm
wheelbase = 2,970mm
estimated after a few "modifications"
tall = 2,100mm
wide = 2,100mm
wheelbase = 2,970mm
RE:how wide are you and how tall ?
Posted: Fri Jan 03, 2003 10:34 pm
by GRUB
My POS is
Height:1990 Thats with 35" muddies
width:1730
Posted: Mon Jan 06, 2003 7:39 pm
by redrocket
93 swb pajero
2030mm short
1850mm thin