bent upper control arm to clear aux fuel tank on GQ
Posted: Mon Jul 23, 2007 2:48 pm
I have seen these before just want to know where to get them from, and to find out if they are any good
Outer Limits 4x4 Board
Aussie Hardcore Wheelers
https://outerlimits4x4.com.au/
bent upper control arm to clear aux fuel tank on GQ
Page 1 of 1
Posted: Mon Jul 23, 2007 4:39 pm
I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
Posted: Mon Jul 23, 2007 4:59 pm
How much?sudso wrote:I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
Posted: Mon Jul 23, 2007 5:03 pm
any one wanna buy a tank modified for this allready in vic ? will have both side tanks l/rsudso wrote:I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
Posted: Mon Jul 23, 2007 5:09 pm
Hobzee off this forum sells them.
he has an ebay shop too but i cant remember its name, just look under nissan patrol till you find the stronger rear arms and there is a link to them there
he has an ebay shop too but i cant remember its name, just look under nissan patrol till you find the stronger rear arms and there is a link to them there
Posted: Mon Jul 23, 2007 6:03 pm
How much?adam penfold wrote:any one wanna buy a tank modified for this allready in vic ? will have both side tanks l/rsudso wrote:I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
Posted: Mon Jul 23, 2007 6:45 pm
http://stores.ebay.com.au/The4wdshop
try that he doesnt have any listed but you can always send him an email i know that he can always get them. hes a top bloke to deal with as well. best of luck.
try that he doesnt have any listed but you can always send him an email i know that he can always get them. hes a top bloke to deal with as well. best of luck.
Posted: Mon Jul 23, 2007 6:52 pm
$400 for bothMKPatrolGuy wrote:How much?adam penfold wrote:any one wanna buy a tank modified for this allready in vic ? will have both side tanks l/rsudso wrote:I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
Posted: Mon Jul 23, 2007 10:59 pm
For you or for your friend in your avatar?chimpboy wrote:How much?sudso wrote:I'll be making "banana" arms soon, upper and lower, from high tensile seamless pipe, and braced.
When I finish my jig and do a run of a few I'll know then.
cheers