Page 1 of 1

NZ jimny utes / Flatdecks

Posted: Wed Jul 25, 2007 2:06 pm
by nicbeer
Are they factory over the pond? seem these are new for $22500NZ

http://www.trademe.co.nz/Trade-Me-Motor ... 568734.htm

http://www.trademe.co.nz/Trade-Me-Motor ... 740148.htm

http://www.trademe.co.nz/Trade-Me-Motor ... 104913.htm


look factory built. i know people were looking at these.

Posted: Wed Jul 25, 2007 2:15 pm
by doddzee
Ive read that they are chopped for the NZ market. They are bought as a full body and the rear door is grafed into the rear.

Was discussed on a NZ forum

http://www.offroadexpress.co.nz/modules ... ight=jimny

Posted: Wed Jul 25, 2007 2:26 pm
by St Jimmy
$ 22'500 nzd pretty good value if you buy them in oz dollars :rofl: :rofl:

Posted: Wed Jul 25, 2007 7:19 pm
by built4thrashing
could these be bought over here and given australian compliance?




hope someone does this

Posted: Wed Jul 25, 2007 7:29 pm
by St Jimmy
they bring yank crap out and get that regod so i couldent see why not as long as its engineered :lol: sorry bout the spelling :oops:

Posted: Wed Jul 25, 2007 8:48 pm
by Gwagensteve
Surely it would be easier to just import the cab back? the tray is just generic.

Steve

Posted: Thu Jul 26, 2007 11:16 am
by robsjimny
There was a company doing them over here too. I think in brissy. I know of a few on the roads here. Would cost abit to get one from NZ. You may still need to engineer it too. Remember all of NZ cars are imports and laws will be different.


Rob

Posted: Thu Jul 26, 2007 4:41 pm
by mugginsmoo
not all cars in NZ are imports, however they have very little in the way of emission laws.
bringing a car from NZ will need to go through complience ($$$$$$ & $)

it would be cheaper to make your own here and engineer it.

Mitch

jimny

Posted: Fri Jul 27, 2007 6:45 pm
by want33s
I'd say it has been cut.. in NZ. If you look closely at the under tray pics you can see where they have welded the tailgate in to make the back wall of the cab. complete with spare wheel depression. I reckon that is the easiest way to do a ute. start with a hardtop not a softtop. The tray looks nothing like a factory unit.

Posted: Fri Jul 27, 2007 8:43 pm
by droopypete
Gwagensteve wrote: the tray is just generic.

Steve

Not to mention dog ugly and poorly made.
Peter.

Posted: Sat Jul 28, 2007 12:33 pm
by ofr57
i know one for sale which i'm thinking on buying as a run around car :cool:
i like them
but i like serrias more

Posted: Mon Jul 30, 2007 8:50 am
by Bad JuJu
Fuel filler is in a crappy spot & you will melt the spare tyre from rear muffler.

And you would fit 3 bales of hay in it - if you were lucky?

Other that it would be cool to be able to get a LWB version here!!