Page 1 of 1
ring and pinion
Posted: Wed Aug 08, 2007 7:37 am
by alanc
Hi,
Can anyone confirm that an L300 85 SD front diff is the same as an early Pajero? It appears the same just looking at it and I assume it is 7.25"
Are ring and pinion sets genuine mitsubishi only or are there aftermarket suppliers?
Regards, Al
Posted: Wed Aug 08, 2007 3:37 pm
by CapnCrunch
What gear ratio do you currently have and what gear ratio are you wanting?
ratios
Posted: Wed Aug 08, 2007 9:01 pm
by alanc
I have 4.875 now.
I want to fit a 9" rear and the common ratios here are 4.9 and 4.636. I will buy a L200/Triton rear end.
4.625 in a 7.25" is fairly common in early Pajero/Raider so that should not be too hard to get. It would be so close to the 4.636 that I could live with the wind up, equivalent to about 1 mm rolling radius on 31s.
If I could get an 11 tooth pinion and 51 tooth ring (4.636) for the 7.25" low pinion then that would be ideal.
Thanks, Al
Posted: Wed Aug 08, 2007 11:35 pm
by CapnCrunch
I would have thought you would have no trouble finding a Gen I Pajero 9" rear end with a 4.625 ring gear. They're fairly abundant here in the States.